QTH.COM Swap Chat

Hello,
I have a Yaesu FT-100D that I was getting ready to put in my mobile when my back went out and I dropped the rig breaking all 4 tabs on the sub panel. I have been searching for this part but with no luck. Does anybody offer any options I may have? I've wondered if someone can create one with a 3D printer. Is this even possible? I do know I can still use it with a remote head bracket but I would rather fix it right if possible. My contact info is good on QRZ and others. At least the rig still works perfectly.
Thanks, Ken - KD1KU

Ken, let me check - I think I have one somewhere, is it the part the head latches into?

Yes, the sub-panel is the part on the main radio body that the head attaches to
Fingers crossed...