SB 36 relay
Posted: Tue Jul 06, 2010 1:54 pm
I am trying to restore a SB36, I have the manual and schemantic, however it does not indicate what the voltage is for the relay in the power supply. Any info would be appreciated. TNX.
If you have the schematic it should be easy enough to trace the
wireing from the relay coil, back to the source voltage.
Wether it be to line volts or maybe 12 DC or even a small regulator off the 12 volts to maybe 5 VDC.
one side of the coil most likely goes to ground, so chase the switched side back to some power point.